NXP Semiconductors LPC24XX UM10237 - Manual (Page 612)

UM10237_4 © NXP B.V. 2009. All rights reserved.
User manual Rev. 04 — 26 August 2009 612 of 792
NXP Semiconductors
UM10237
Chapter 23: LPC24XX I 2 S interface
next falling edge of the transmitting clock after a WS change. In stereo mode when WS is
low left data is transmitted and right data when WS is high. In mono mode the same data
is transmitted twice, once when WS is low and again when WS is high.
• In master mode (ws_sel = 0), word select is generated internally with a 9 bit counter.
The half period count value of this counter can be set in the control register.
• In slave mode (ws_sel = 1) word select is input from the relevant bus pin.
• When an I 2 S bus is active, the word select, receive clock and transmit clock signals
are sent continuously by the bus master, while data is sent continuously by the
transmitter.
• Disabling the I 2 S can be done with the stop or mute control bits separately for the
transmit and receive.
• The stop bit will disable accesses by the transmit channel or the receive channel to
the FIFOs and will place the transmit channel in mute mode.
• The mute control bit will place the transmit channel in mute mode. In mute mode, the
transmit channel FIFO operates normally, but the output is discarded and replaced by
zeroes. This bit does not affect the receive channel, data reception can occur
normally.
4. Pin descriptions
Table 530. Pin descriptions
Pin Name Type Description
I2SRX_CLK Input/Output Receive Clock. A clock signal used to synchronize the transfer of
data on the receive channel. It is driven by the master and received
by the slave. Corresponds to the signal SCK in the I
2 S bus
specification.
I2SRX_WS Input/Output Receive Word Select. Selects the channel from which data is to be
received. It is driven by the master and received by the slave.
Corresponds to the signal WS in the I
2 S bus specification.
WS = 0 indicates that data is being received by channel 1 (left
channel).
WS = 1 indicates that data is being received by channel 2 (right
channel).
I2SRX_SDA Input/Output Receive Data. Serial data, received MSB first. It is driven by the
transmitter and read by the receiver. Corresponds to the signal SD
in the I
2 S bus specification.
I2STX_CLK Input/Output Transmit Clock. A clock signal used to synchronize the transfer of
data on the transmit channel. It is driven by the master and received
by the slave. Corresponds to the signal SCK in the I
2 S bus
specification.
I2STX_WS Input/Output Transmit Word Select. Selects the channel to which data is being
sent. It is driven by the master and received by the slave.
Corresponds to the signal WS in the I
2 S bus specification.
WS = 0 indicates that data is being sent to channel 1 (left channel).
WS = 1 indicates that data is being sent to channel 2 (right channel).
I2STX_SDA Input/Output Transmit Data. Serial data, sent MSB first. It is driven by the
transmitter and read by the receiver. Corresponds to the signal SD
in the I
2 S bus specification.