NXP Semiconductors LPC24XX UM10237 - Manual (Page 5)

UM10237_4 © NXP B.V. 2009. All rights reserved.
User manual Rev. 04 — 26 August 2009 5 of 792
NXP Semiconductors
UM10237
Chapter 1: LPC24XX Introductory information
– SPI controller.
– Two SSP controllers, with FIFO and multi-protocol capabilities. One is an alternate
for the SPI port, sharing its interrupt. SSPs can be used with the GPDMA
controller.
– Three I 2 C-bus interfaces (one with open-drain and two with standard port pins).
– I 2 S (Inter-IC Sound) interface for digital audio input or output. It can be used with
the GPDMA.
• Other peripherals:
– SD/MMC memory card interface.
– 160 general purpose I/O pins with configurable pull-up/down resistors.
– 10-bit ADC with input multiplexing among 8 pins.
– 10-bit DAC.
– Four general purpose timers/counters with 8 capture inputs and 10 compare
outputs. Each timer block has an external count input.
– Two PWM/timer blocks with support for three-phase motor control. Each PWM has
an external count inputs.
– Real-Time Clock (RTC) with separate power domain, clock source can be the RTC
oscillator or the APB clock.
– 2 kB SRAM powered from the RTC power pin, allowing data to be stored when the
rest of the chip is powered off.
– WatchDog Timer (WDT). The WDT can be clocked from the internal RC oscillator,
the RTC oscillator, or the APB clock.
• Standard ARM test/debug interface for compatibility with existing tools.
• Emulation trace module supports real-time trace.
• Single 3.3 V power supply (3.0 V to 3.6 V).
• Four reduced power modes: idle, sleep, power-down, and deep power-down.
• Four external interrupt inputs configurable as edge/level sensitive. All pins on PORT0
and PORT2 can be used as edge sensitive interrupt sources.
• Processor wake-up from Power-down mode via any interrupt able to operate during
Power-down mode (includes external interrupts, RTC interrupt, USB activity, Ethernet
wake-up interrupt, CAN bus activity, PORT0/2 pin interrupt).
• Two independent power domains allow fine tuning of power consumption based on
needed features.
• Each peripheral has its own clock divider for further power saving. These dividers help
reducing active power by 20 - 30 %.
• Brownout detect with separate thresholds for interrupt and forced reset.
• On-chip power-on reset.
• On-chip crystal oscillator with an operating range of 1 MHz to 24 MHz.
• 4 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as
the system clock. When used as the CPU clock, does not allow CAN and USB to run.
• On-chip PLL allows CPU operation up to the maximum CPU rate without the need for
a high frequency crystal. May be run from the main oscillator, the internal RC
oscillator, or the RTC oscillator.