H3C Technologies H3C SecPath F1000-E - Manual (Page 952)

927
[SecPathA-route-policy] quit
# Enable RIPng and apply routing policy static2ripng to filter redistributed static routes on SecPath
A.
[SecPathA] ripng
[SecPathA-ripng-1] import-route static route-policy static2ripng
2. Configure SecPath B:
# Configure the IPv6 address of GigabitEthernet 0/1.
system-view
[SecPathB] ipv6
[SecPathB] interface GigabitEthernet 0/1
[SecPathB-GigabitEthernet0/1] ipv6 address 10::2 32
# Enable RIPng on the interface.
[SecPathB-GigabitEthernet0/1] ripng 1 enable
[SecPathB-GigabitEthernet0/1] quit
# Enable RIPng.
[SecPathB] ripng
# Display RIPng routing table information.
[SecPathB-ripng-1] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::7D58:0:CA03:1 on GigabitEthernet0/1
Dest 10::/32,
via FE80::7D58:0:CA03:1, cost 1, tag 0, A, 18 Sec
Dest 20::/32,
via FE80::7D58:0:CA03:1, cost 1, tag 0, A, 8 Sec
Dest 40::/32,
via FE80::7D58:0:CA03:1, cost 1, tag 0, A, 3 Sec
Applying a routing policy to filter received BGP routes
Network requirements
• In Figure 406 , all the firewalls run BGP. SecPath C establishes EBGP connections with other
firewalls.
• Configure a routing policy on SecPath D to reject routes from AS 200.