H3C Technologies H3C SecPath F1000-E - Manual (Page 446)

421
Routing for ASEs
Destination Cost Type Tag NextHop AdvRouter
3.1.2.0/24 1 Type2 1 10.3.1.1 10.4.1.1
Total Nets: 6
Intra Area: 2 Inter Area: 3 ASE: 1 NSSA: 0
Configuring OSPF to advertise a summary route at the CLI
Network requirements
As shown in Figure 269 :
• Router A and SecPath are in AS 200, running OSPF.
• Router B, Router C, and Router D are in AS 100, running OSPF.
An EBGP connection is established between SecPath and Router B. SecPath and Router B are configured
to redistribute OSPF routes and direct routes into BGP and BGP routes into OSPF.
SecPath is configured with route summarization and advertises only the summary route 10.0.0.0/8 to
reduce Router A's routing table size.
Figure 269 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure OSPF basic functions:
# Configure Router A.
system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 11.2.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit