H3C Technologies H3C SecPath F1000-E - Manual (Page 690)

665
[RouterB-GigabitEthernet0/1] quit
[RouterB] interface GigabitEthernet 0/2
[RouterB-GigabitEthernet0/2] igmp enable
[RouterB-GigabitEthernet0/2] pim sm
[RouterB-GigabitEthernet0/2] quit
[RouterB] interface GigabitEthernet 0/3
[RouterB-GigabitEthernet0/3] pim sm
[RouterB-GigabitEthernet0/3] quit
The configuration on SecPath A, Router A, SecPath B, Router C, Router D, and SecPath C is similar
to that on Router B. (Details not shown.)
# Configure PIM domain borders on Router A.
[RouterA] interface GigabitEthernet 0/3
[RouterA-GigabitEthernet0/3] pim bsr-boundary
[RouterA-GigabitEthernet0/3] quit
The configuration on Router B, SecPath B, and Router D is similar to that on Router A. (Details not
shown.)
3. Configure C-BSRs and C-RPs:
# Configure Loopback 0 as a C-BSR and a C-RP on SecPath A.
[SecPathA] pim
[SecPathA-pim] c-bsr loopback 0
[SecPathA-pim] c-rp loopback 0
[SecPathA-pim] quit
The configuration on SecPath B and SecPath C is similar to that on SecPath A. (Details not shown.)
4. Configure BGP, and redistribute BGP routing information into OSPF and OSPF routing information
into BGP:
# Configure an EBGP peer, and redistribute OSPF routing information on Router A.
[RouterA] bgp 100
[RouterA-bgp] router-id 1.1.1.2
[RouterA-bgp] peer 10.110.3.2 as-number 200
[RouterA-bgp] import-route ospf 1
[RouterA-bgp] quit
# Configure an EBGP peer, and redistribute OSPF routing information on SecPath B.
[SecPathB] bgp 200
[SecPathB-bgp] router-id 2.2.2.2
[SecPathB-bgp] peer 10.110.3.1 as-number 100
[SecPathB-bgp] import-route ospf 1
[SecPathB-bgp] quit
# Configure an EBGP peer, and redistribute OSPF routing information on Router B.
[RouterB] bgp 100
[RouterB-bgp] router-id 1.1.1.3
[RouterB-bgp] peer 10.110.4.2 as-number 200
[RouterB-bgp] import-route ospf 1
[RouterB-bgp] quit
# Configure an EBGP peer, and redistribute OSPF routing information on Router D.
[RouterD] bgp 200
[RouterD-bgp] router-id 3.3.3.1