H3C Technologies H3C SecPath F1000-E - Manual (Page 655)

630
Task Command Remarks
Display the number of PIM control
messages.
display pim control-message counters
[ message-type { probe | register |
register-stop } | [ interface
interface-type interface-number |
message-type { assert | bsr | crp |
graft | graft-ack | hello | join-prune |
state-refresh } ] * ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display information about
unacknowledged PIM-DM graft
messages.
display pim grafts [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display PIM information on an
interface or all interfaces.
display pim interface [ interface-type
interface-number ] [ verbose ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display information about join/prune
messages to send.
display pim join-prune mode { sm
[ flags flag-value ] | ssm } [ interface
interface-type interface-number |
neighbor neighbor-address ] *
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display PIM neighboring information.
display pim neighbor [ interface
interface-type interface-number |
neighbor-address | verbose ] * [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display PIM routing table information.
display pim routing-table
[ group-address [ mask { mask-length |
mask } ] | source-address [ mask
{ mask-length | mask } ] |
incoming-interface [ interface-type
interface-number | register ] |
outgoing-interface { include | exclude
| match } { interface-type
interface-number | register } | mode
mode-type | flags flag-value | fsm ] *
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display RP information.
display pim rp-info [ group-address ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Reset PIM control message counters.
reset pim control-message counters
[ interface interface-type
interface-number ]
Available in user view
PIM configuration examples at the CLI
This section provides examples of configuring PIM on firewalls.