H3C Technologies H3C SecPath F1000-E - Manual (Page 802)

777
[RouterB-GigabitEthernet0/1] quit
[RouterB] interface GigabitEthernet0/2
[RouterB-GigabitEthernet0/2] ospfv3 1 area 0
[RouterB-GigabitEthernet0/2] quit
# Configure Router C. Enable OSPFv3 and configure the router ID as 3.3.3.3.
system-view
[RouterC] ipv6
[RouterC] ospfv3 1
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface GigabitEthernet0/1
[RouterC-GigabitEthernet0/1] ospfv3 1 area 0
[RouterC-GigabitEthernet0/1] quit
[RouterC] interface GigabitEthernet0/2
[RouterC-GigabitEthernet0/2] ospfv3 1 area 0
[RouterC-GigabitEthernet0/2] quit
3. Configure BFD:
# Enable BFD on SecPath A and configure BFD parameters.
[SecPathA] bfd session init-mode active
[SecPathA] interface GigabitEthernet0/1
[SecPathA-GigabitEthernet0/1] ospfv3 bfd enable
[SecPathA-GigabitEthernet0/1] bfd min-transmit-interval 500
[SecPathA-GigabitEthernet0/1] bfd min-receive-interval 500
[SecPathA-GigabitEthernet0/1] bfd detect-multiplier 7
[SecPathA-GigabitEthernet0/1] return
# Enable BFD on Router B and configure BFD parameters.
[RouterB] bfd session init-mode active
[RouterB] interface GigabitEthernet0/1
[RouterB-GigabitEthernet0/1] ospfv3 bfd enable
[RouterB-GigabitEthernet0/1] bfd min-transmit-interval 500
[RouterB-GigabitEthernet0/1] bfd min-receive-interval 500
[RouterB-GigabitEthernet0/1] bfd detect-multiplier 6
4. Verify the configuration:
The following operations are performed on SecPath A. The operations on Router B are similar.
(Details not shown.)
# Display the BFD information of SecPath A.
display bfd session
Total Session Num: 1 Init Mode: Active
IPv6 Session Working Under Ctrl Mode:
Local Discr: 1441 Remote Discr: 1450
Source IP: FE80::20F:FF:FE00:1202 (link-local address of GigabitEthernet0/1
on SecPath A)
Destination IP: FE80::20F:FF:FE00:1200 (link-local address of GigabitEthernet0/1
on Router B)
Session State: Up Interface: GigabitEthernet0/1