H3C Technologies H3C SecPath F1000-E - Manual (Page 462)

437
Figure 275 Network diagram
Device Interface IP address Device Interface IP address
SecPath A GE0/1 192.168.0.102/24 Router B GE0/1 192.168.0.100/24
GE0/2 10.1.1.102/24 GE0/2 13.1.1.1/24
Router C GE0/1 10.1.1.100/24
GE0/2 13.1.1.2/24
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure OSPF basic functions:
# Configure SecPath A.
system-view
[SecPathA] ospf
[SecPathA-ospf-1] area 0
[SecPathA-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] network 121.1.1.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] quit
[SecPathA-ospf-1] quit
[SecPathA] interface GigabitEthernet0/2
[SecPathA-GigabitEthernet0/2] ospf cost 2
# Configure Router B.
system-view
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] network 120.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
[RouterB-ospf-1] quit
[RouterB] interface GigabitEthernet0/2
[RouterB-GigabitEthernet0/2] ospf cost 2
# Configure Router C.
system-view
[RouterC] ospf
Eth1/1 Eth1/1
Router A
Router B
BFD
L2 Switch
Area 0
Router C
Eth1/1 Eth1/2
Eth1/2 Eth1/2
120.1.1.0/24 121.1.1.0/24