Solution – H3C Technologies H3C SecPath F1000-E User Manual
Page 921
896
Solution
1.
Use the display ipv6 routing-table command to verify that routes are available on each router to
the RP and the BSR, and that a route is available between the RP and the BSR. Make sure that each
C-RP has a unicast route to the BSR, the BSR has a unicast route to each C-RP, and all the routers
in the entire network have a unicast route to the RP.
2.
IPv6 PIM-SM needs the support of the RP and BSR. Use the display pim ipv6 bsr-info command to
verify that the BSR information is available on each router, and then use the display pim ipv6
rp-info command to verify that the RP information is correct.
3.
Use the display pim ipv6 neighbor command to verify that normal neighboring relationships have
been established among the routers.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer