H3C Technologies H3C SecPath F1000-E - Manual (Page 167)

142
Blackhole-type inline forwarding configuration example in the
Web interface
Network requirements
Packets coming from GigabitEthernet 0/1 must be discarded. Configure blackhole-type inline
forwarding on Ethernet 0/1.
Creating a blackhole-type inline forwarding policy
NOTE:
Before configuration, make sure that GigabitEthernet 0/1 operates in bridge mode and it is added to a
zone.
• Select Network > Forwarding from the navigation tree. On the page, click Add to enter the page
for adding an inline forwarding policy.
Figure 77 Adding a blackhole-type inline forwarding policy
• Enter policy ID 1.
• Select Blackhole as the policy type.
• Select GigabitEthernet0/1 from the Port 1 list.
• Click Apply.
Configuring inline forwarding at the CLI
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure an inline Layer 2
forwarding entry. inline-interfaces id
[ blackhole | reflect ]
N/A
3. Enter Layer 2 Ethernet
interface view. interface interface-type
interface-number
N/A
4. Assign an interface to the
inline Layer 2 forwarding
entry.
port inline-interfaces id
By default, the interface does not belong to any
inline Layer 2 forwarding entry.
Two interfaces must be assigned to the
forward-type inline forwarding entry while one
interface is required for the reflect or blackhole
type.