H3C Technologies H3C SecPath F1000-E - Manual (Page 919)

894
Total number of downstreams: 1
1: GigabitEthernet0/1
Protocol: mld, UpTime: 00:00:11, Expires: 00:03:25
# Display IPv6 PIM multicast routing table information on SecPath B.
[SecPathB] display pim ipv6 routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(4001::100, FF3E::101)
Protocol: pim-ssm, Flag: LOC
UpTime: 00:08:02
Upstream interface: GigabitEthernet0/1
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet0/2
Protocol: pim-ssm, UpTime: 00:08:02, Expires: 00:03:25
Troubleshooting IPv6 PIM
Failure of building a multicast distribution tree correctly
Symptom
None of the routers in the network (including routers directly connected with IPv6 multicast sources and
receivers) has IPv6 multicast forwarding entries. That is, a multicast distribution tree cannot be built
correctly and clients cannot receive IPv6 multicast data.
Analysis
• An IPv6 PIM routing entry is created based on an IPv6 unicast route, whichever IPv6 PIM mode is
running. Multicast works only when unicast does.
• IPv6 PIM must be enabled on the RPF interface. An RPF neighbor must be an IPv6 PIM neighbor as
well. If IPv6 PIM is not enabled on the RPF interface or the RPF neighbor, the establishment of a
multicast distribution tree will surely fail, resulting in abnormal multicast forwarding.
• IPv6 PIM requires that the same IPv6 PIM mode—namely, DM or SM—must run on the entire
network. Otherwise, the establishment of a multicast distribution tree will surely fail, resulting in
abnormal multicast forwarding.
Solution
1. Use the display ipv6 routing-table command to verify that a unicast route exists to the IPv6
multicast source or the RP.
2. Use the display pim ipv6 interface command to verify that the RPF interface is IPv6 PIM enabled.
If IPv6 PIM is not enabled on the interface, use the pim ipv6 dm or pim ipv6 sm command to enable
IPv6 PIM.
3. Use the display pim ipv6 neighbor command to verify that the RPF neighbor is an IPv6 PIM
neighbor. .