H3C Technologies H3C SecPath F1000-E - Manual (Page 584)

559
The debugging information about PBR displayed on SecPath is as follows:
*Jun 7 12:04:33:519 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2
*Jun 7 12:04:34:518 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2
*Jun 7 12:04:35:518 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2
*Jun 7 12:04:36:518 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2
The preceding information shows that SecPath sets the next hop for the received packets to
150.1.1.2 according to PBR. The packets are forwarded via GigabitEthernet 0/2.
# Ping Loopback 0 of Router from Host A, and set the data section length to 200 bytes.
C:\>ping -l 200 10.1.1.1
Pinging 10.1.1.1 with 200 bytes of data:
Reply from 10.1.1.1: bytes=200 time<1ms TTL=255
Reply from 10.1.1.1: bytes=200 time<1ms TTL=255
Reply from 10.1.1.1: bytes=200 time<1ms TTL=255
Reply from 10.1.1.1: bytes=200 time<1ms TTL=255
Ping statistics for 10.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
The debugging information about PBR displayed on SecPath is as follows:
*Jun 7 12:06:47:631 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
*Jun 7 12:06:48:630 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
*Jun 7 12:06:49:627 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
*Jun 7 12:06:50:627 2009 SecPath PBR/7/POLICY-ROUTING: IP policy based routing
success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2
The preceding information shows that SecPath sets the next hop for the received packets to
151.1.1.2 according to PBR. The packets are forwarded via GigabitEthernet 0/3.
Configuring local PBR to specify outgoing interface and next
hop at the CLI
Network requirements
As shown in Figure 317 :