H3C Technologies H3C SecPath F1000-E - Manual (Page 665)

640
Figure 347 Network diagram
Device Interface IP address Device Interface IP address
Router A GE0/1 192.168.1.1/24 SecPath B GE0/1 10.110.8.1/24
GE0/2 10.110.1.1/24 GE0/2 10.110.7.1/24
SecPath A GE0/1 192.168.2.1/24 GE0/3 10.110.4.2/24
GE0/2 10.110.3.1/24 Router D GE0/1 192.168.4.1/24
GE0/3 10.110.2.1/24 GE0/2 10.110.5.2/24
GE0/4 10.110.1.2/24 GE0/3 10.110.7.2/24
Router C GE0/1 10.110.2.2/24 SecPath C GE0/1 10.110.9.1/24
GE0/2 10.110.4.1/24 GE0/2 10.110.8.2/24
GE0/3 10.110.5.1/24 GE0/3 10.110.3.2/24
GE0/4 192.168.3.1/24 Router B GE0/1 192.168.5.1/24
GE0/5 10.110.6.1/24 GE0/2 10.110.9.2/24
Router E GE0/1 10.110.10.1/24 Source 1 — 192.168.2.10/24
GE0/2 10.110.6.2/24 Source 2 — 192.168.3.10/24
Router F GE0/1 10.110.10.2/24 Source 3 — 192.168.5.10/24
GE0/2 192.168.6.1/24
Configuration procedure
1. Configure IP addresses and unicast routing:
Configure the IP address and subnet mask for each interface as per
Figure 347 . (Details not
shown.)
Configure OSPF on the routers and firewalls in the PIM-SM domain to make sure the network-layer
on the PIM-SM network is interoperable and routing information among routers and firewalls can
be dynamically updated. (Details not shown.)
Router A SecPath A
ZBR
Router C
ZBR
SecPath B
ZBR
Router D
Router E Router F
SecPath C
Router B
Source 3
Source 1
Source 2
Receiver
Host A
GE0/2
GE
0/3
G
E0
/1
GE0/4
GE0/5 GE0/3
GE0/2
GE0/1
GE0/2
GE0/1
GE0/2
GE0/1
G
E0/2
GE0/3
GE0/1
GE0/1
GE0/1 GE0/2
G
E0/2
GE0/1 GE0/1
GE0/3
GE0/2 GE0/3 GE0/2
GE0/4
Admin-scope 2
PIM-SM
Global-scope
Admin-scope 1
Receiver
Host B
Receiver
Host C