H3C Technologies H3C SecPath F1000-E - Manual (Page 370)

345
# Configure static routes on SecPath A and enable BFD control packet mode for the static route
through Router D.
system-view
[SecPathA] interface loopback 1
[SecPathA-LoopBack1] bfd min-transmit-interval 500
[SecPathA-LoopBack1] bfd min-receive-interval 500
[SecPathA-LoopBack1] bfd detect-multiplier 9
[SecPathA-LoopBack1] quit
[SecPathA] ip route-static 120.1.1.0 24 2.2.2.9 bfd control-packet bfd-source 1.1.1.9
[SecPathA] ip route-static 120.1.1.0 24 GigabitEthernet0/2 10.1.1.100 preference 65
[SecPathA] quit
# Configure static routes on Router B and enable BFD control packet mode for the static route
through Router D.
system-view
[RouterB] interface loopback 1
[RouterB-LoopBack1] bfd min-transmit-interval 500
[RouterB-LoopBack1] bfd min-receive-interval 500
[RouterB-LoopBack1] bfd detect-multiplier 9
[RouterB-LoopBack1] quit
[RouterB] ip route-static 121.1.1.0 24 1.1.1.9 bfd control-packet bfd-source 2.2.2.9
[RouterB] ip route-static 121.1.1.0 24 GigabitEthernet0/2 13.1.1.2 preference 65
[RouterB] quit
3. Verify the configuration:
The following operations are performed on SecPath A. The operations on Router B are similar.
# Display BFD sessions on SecPath A.
display bfd session
Total Session Num: 1 Init Mode: Active
Session Working Under Ctrl Mode:
LD/RD SourceAddr DestAddr State Holdtime Interface
4/7 1.1.1.9 2.2.2.9 Up 2000ms Loop1
# Display static routes on SecPath A.
display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : < Active>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 60 0 2.2.2.9 GigabitEthernet0/1
Static Routing table Status :
Summary Count : 1