Configuring a policy and the policy node, Creating a policy – H3C Technologies H3C SecPath F1000-E User Manual
Page 566
541
Task Remarks
Enabling
local PBR
Optional.
Only one policy can be referenced when local PBR is enabled.
Local PBR is not configured by default.
IMPORTANT:
Unless otherwise required, H3C does not recommend enabling local PBR.
Enabling
interface
PBR
Required.
Only one policy can be referenced when PBR is enabled on an interface.
Interface PBR is not configured by default.
Configuring a policy and the policy node
Creating a policy
Select Network > Routing Management > Policy Routing from the navigation tree to enter the default
policy configuration page, as shown in
. Click Add to enter the policy configuration page, as
shown in
. You can create a policy and configure its policy node on the page.
Figure 302 Policy configuration page
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer