Pim configuration example in the web interface, Network requirements – H3C Technologies H3C SecPath F1000-E User Manual
Page 632
607
Figure 339 PIM neighbor information
Table 81 Field description
Field Description
Interface
Name of the interface connecting to a PIM neighbor.
Neighbor address
IP address of a PIM neighbor.
Uptime
Length of time for which the PIM neighbor has been up, where a
"01:02:11:32:18" value means that the neighbor has been up for 1 week, 2
days, 11 hours, 32 minutes, and 18 seconds.
Remaining lifetime
Remaining lifetime of the PIM neighbor, where a "00:02:45" value means that
the neighbor will time out in 2 minutes and 45 seconds and "never" means that
the PIM neighbor never times out.
PIM configuration example in the Web interface
Network requirements
As shown in
, receivers receive VOD information through multicast. The receiver groups of
different organizations form stub networks, and one or more receiver hosts exist in each stub network. The
entire PIM domain operates in the dense mode.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
IGMPv2 runs between SecPath A and N1 and between SecPath B and N2.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer