H3C Technologies H3C SecPath F1000-E - Manual (Page 799)

774
[SecPathB-ospfv3-2] router-id 3.3.3.3
[SecPathB-ospfv3-2] quit
[SecPathB] interface GigabitEthernet 0/1
[SecPathB-GigabitEthernet0/1] ospfv3 2 area 2
[SecPathB-GigabitEthernet0/1] quit
# Enable OSPFv3 process 2 on SecPath C.
system-view
[SecPathC] ipv6
[SecPathC] ospfv3 2
[SecPathC-ospfv3-2] router-id 4.4.4.4
[SecPathC-ospfv3-2] quit
[SecPathC] interface GigabitEthernet 0/2
[SecPathC-GigabitEthernet0/2] ospfv3 2 area 2
[SecPathC-GigabitEthernet0/2] quit
[SecPathC] interface GigabitEthernet 0/1
[SecPathC-GigabitEthernet0/1] ospfv3 2 area 2
[SecPathC-GigabitEthernet0/1] quit
# Display the routing table of SecPath C.
[SecPathC] display ipv6 routing-table
Routing Table :
Destinations : 6 Routes : 6
Destination: ::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 3::/64 Protocol : Direct
NextHop : 3::2 Preference: 0
Interface : GE0/2 Cost : 0
Destination: 3::2/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 4::/64 Protocol : Direct
NextHop : 4::1 Preference: 0
Interface : GE0/1 Cost : 0
Destination: 4::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
3. Configure OSPFv3 route redistribution:
# Configure OSPFv3 process 2 to redistribute direct routes and the routes from OSPFv3 process 1
on SecPath B.