H3C Technologies H3C SecPath F1000-E - Manual (Page 772)

747
Peer FE80::20F:E2FF:FE23:82F5 on GigabitEthernet0/1
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Peer FE80::20F:E2FF:FE00:100 on GigabitEthernet0/2
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
[SecPathA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235 on GigabitEthernet0/1
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost 1, tag 0, A, 2 Sec
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Configuring RIPng route redistribution
Network requirements
• Two RIPng processes are running on SecPath B, which communicates with SecPath A through RIPng
100 and with SecPath C through RIPng 200.
• Configure route redistribution on SecPath B, letting the two RIPng processes redistribute routes from
each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 381 Network diagram
Configuration procedure
1. Configure IPv6 addresses for the interfaces. (Details not shown.)
2. Configure RIPng basic functions:
# Enable RIPng 100 on SecPath A.
system-view
[SecPathA] ripng 100
[SecPathA-ripng-100] quit
[SecPathA] interface GigabitEthernet 0/1