H3C Technologies H3C SecPath F1000-E - Manual (Page 907)

882
# On SecPath B, configure GigabitEthernet 0/4 and GigabitEthernet 0/5 as the boundary of IPv6
admin-scoped zone 2.
system-view
[SecPathB] interface GigabitEthernet 0/4
[SecPathB-GigabitEthernet0/4] multicast ipv6 boundary scope 4
[SecPathB-GigabitEthernet0/4] quit
[SecPathB] interface GigabitEthernet 0/5
[SecPathB-GigabitEthernet0/5] multicast ipv6 boundary scope 4
[SecPathB-GigabitEthernet0/5] quit
# On Router B, configure GigabitEthernet 0/1 as the boundary of admin-scoped zone 2.
system-view
[RouterB] interface Gigabitethernet 0/1
[RouterB-GigabitEthernet0/1] multicast ipv6 boundary scope 4
[RouterB-GigabitEthernet0/1] quit
4. Configure C-BSRs and C-RPs:
# On SecPath A, configure the service scope of RP advertisements and configure GigabitEthernet
0/2 as a C-BSR and C-RP of admin-scoped zone 1.
[SecPathA] pim ipv6
[SecPathA-pim6] c-bsr scope 4
[SecPathA-pim6] c-bsr 1002::2
[SecPathA-pim6] c-rp 1002::2 scope 4
[SecPathA-pim6] quit
# On Router B, configure the service scope of RP advertisements and configure GigabitEthernet
0/3 as a C-BSR and C-RP of admin-scoped zone 2.
[RouterB] pim ipv6
[RouterB-pim6] c-bsr scope 4
[RouterB-pim6] c-bsr 3002::2
[RouterB-pim6] c-rp 3002::2 scope 4
[RouterB-pim6] quit
# On SecPath C, configure GigabitEthernet 0/1 as a C-BSR and C-RP in the global-scoped zone.
system-view
[SecPathC] pim ipv6
[SecPathC-pim6] c-bsr scope global
[SecPathC-pim6] c-bsr 8001::1
[SecPathC-pim6] c-rp 8001::1
[SecPathC-pim6] quit
5. Verify the configuration:
To display BSR election information and C-RP information on a firewall, use the display pim ipv6
bsr-info command. For example:
# Display BSR information and locally configured C-RP information on SecPath A.
[SecPathA] display pim ipv6 bsr-info
Elected BSR Address: 8001::1
Priority: 64
Hash mask length: 126
State: Accept Preferred
Scope: 14
Uptime: 00:01:45