H3C Technologies H3C SecPath F1000-E - Manual (Page 686)

661
[SecPathA-msdp] quit
# Configure MSDP peers on SecPath B.
[SecPathB] msdp
[SecPathB-msdp] peer 192.168.1.1 connect-interface GigabitEthernet 0/1
[SecPathB-msdp] peer 192.168.3.2 connect-interface GigabitEthernet 0/2
[SecPathB-msdp] quit
# Configure an MSDP peer on SecPath C.
[SecPathC] msdp
[SecPathC-msdp] peer 192.168.3.1 connect-interface GigabitEthernet 0/2
[SecPathC-msdp] quit
6. Verify the configuration:
Use the display bgp peer command to display BGP peering relationship between the firewalls. For
example:
# Display information about BGP peering relationship on SecPath A.
[SecPathA] display bgp peer
BGP local router ID : 1.1.1.1
Local AS number : 100
Total number of peers : 1 Peers in established state : 1
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
192.168.1.2 200 24 21 0 6 00:13:09 Established
# Display information about BGP peering relationship on SecPath B.
[SecPathB] display bgp peer
BGP local router ID : 2.2.2.2
Local AS number : 200
Total number of peers : 1 Peers in established state : 1
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
192.168.1.1 100 18 16 0 1 00:12:04 Established
To display BGP routing table information on the firewalls, use the display bgp routing-table
command. For example:
# Display BGP routing table information on SecPath B.
[SecPathB] display bgp routing-table
Total Number of Routes: 5
BGP Local router ID is 2.2.2.2
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
h - history, i - internal, s - suppressed, S - Stale
Origin : i - IGP, e - EGP, ? - incomplete
Network NextHop MED LocPrf PrefVal Path/Ogn