H3C Technologies H3C SecPath F1000-E - Manual (Page 602)

577
Solution
1. Use the display multicast routing-table static command to display the information of static multicast
routes to verify that the static multicast route has been correctly configured and the route entry
exists in the multicast routing table.
2. Check the type of the next hop interface of the static multicast route. If the interface is not a
point-to-point interface, be sure to specify the next hop address for the outgoing interface when
you configure the static multicast route.
3. Check that the static multicast route matches the specified routing protocol. If a protocol was
specified in static multicast route configuration, enter the display ip routing-table command to
check if an identical route was added by the protocol.
4. Check that the static multicast route matches the specified routing policy. If a routing policy was
specified when the static multicast route was configured, enter the display route-policy command
to check the configured routing policy.