H3C Technologies H3C SecPath F1000-E - Manual (Page 583)

558
[SecPath-GigabitEthernet0/1] quit
# Configure the IP addresses of GigabitEthernet 0/2 and GigabitEthernet 0/3.
[SecPath] interface GigabitEthernet 0/2
[SecPath-GigabitEthernet0/2] ip address 150.1.1.1 255.255.255.0
[SecPath-GigabitEthernet0/2] quit
[SecPath] interface GigabitEthernet 0/3
[SecPath-GigabitEthernet0/3] ip address 151.1.1.1 255.255.255.0
[SecPath-GigabitEthernet0/3] quit
2. Configure Router:
# Configure RIP.
system-view
[Router] rip
[Router-rip-1] network 10.0.0.0
[Router-rip-1] network 150.1.0.0
[Router-rip-1] network 151.1.0.0
# Configure the IP addresses of GigabitEthernet 0/1 and GigabitEthernet 0/2.
[Router] interface GigabitEthernet 0/1
[Router-GigabitEthernet0/1] ip address 150.1.1.2 255.255.255.0
[Router-GigabitEthernet0/1] quit
[Router] interface GigabitEthernet 0/2
[Router-GigabitEthernet0/2] ip address 151.1.1.2 255.255.255.0
[Router-GigabitEthernet0/2] quit
# Configure the loopback interface address.
[Router] interface loopback 0
[Router-LoopBack0] ip address 10.1.1.1 32
3. Verify the configuration:
# Run the debugging ip policy-based-route command on SecPath.
debugging ip policy-based-route
terminal debugging
terminal monitor
Configure the IP address of Host A as 192.1.1.3/24 and the gateway as 192.1.1.1.
# Ping Loopback 0 of Router from Host A, and set the data section length to 50 bytes.
C:\>ping -l 50 10.1.1.1
Pinging 10.1.1.1 with 50 bytes of data:
Reply from 10.1.1.1: bytes=50 time<1ms TTL=255
Reply from 10.1.1.1: bytes=50 time<1ms TTL=255
Reply from 10.1.1.1: bytes=50 time<1ms TTL=255
Reply from 10.1.1.1: bytes=50 time<1ms TTL=255
Ping statistics for 10.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms