H3C Technologies H3C SecPath F1000-E - Manual (Page 439)

414
Step Command Remarks
4. Exit to system view. quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Enable BFD control packet bidirectional
detection on the interface.
ospf bfd enable
Not enabled by
default.
NOTE:
•
One network segment can only belong to one area.
• Both ends of a BFD session must be on the same network segment and in the same area.
Configuring echo packet single-hop detection
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the source address of echo
packets.
bfd echo-source-ip ip-address
Not configured by
default.
3. Enable an OSPF process and enter OSPF
view. ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
4. Specify a network to enable OSPF on the
interface attached to the network.
network ip-address wildcard-mask N/A
5. Return to system view. quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable BFD echo packet single-hop
detection on the interface.
ospf bfd enable echo
Not enabled by
default.
Displaying and maintaining OSPF
Task Command Remarks
Display OSPF brief information.
display ospf [ process-id ] brief [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display OSPF statistics.
display ospf [ process-id ] cumulative
[ | { begin | exclude | include }
regular-expression ]
Available in any view