Pbr configuration example in the web interface, Network requirements, N in – H3C Technologies H3C SecPath F1000-E User Manual
Page 570: Figure 307
545
Figure 307 Applying a policy
Table 74 Configuration items
Item Description
Apply to
Specify the policy application mode:
•
Local—Enables local PBR. Unless otherwise required, H3C does not recommend
enabling local PBR.
•
Interface—Enables interface PBR. Apply the policy on a selected interface.
Policy Name
Enter the name of the policy to be applied.
PBR configuration example in the web interface
Network requirements
As shown in
, configure PBR based on policy aaa to send TCP packets received from
GigabitEthernet 0/1 through GigabitEthernet 0/2 (assume GigabitEthernet 0/2 has only one next hop
connected). Non-TCP packets are forwarded based on the routing table.
Figure 308 Network diagram
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer