H3C Technologies H3C SecPath F1000-E - Manual (Page 428)

403
Step Command Remarks
3. Configure an OSPF cost for the
interface.
ospf cost value
Optional.
The default cost depends on
the interface type: 1 for a
VLAN interface; 0 for a
loopback interface; computed
according to the bandwidth
for other interfaces.
To configure a bandwidth reference value:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
Optional.
The value defaults to 100
Mbps.
Configuring the maximum number of OSPF routes
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A
3. Configure the maximum number
of OSPF routes. maximum-routes { external | inter |
intra } number
Optional.
Configuring the maximum number of ECMP routes
Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] * N/A
3. Configure the maximum number
of ECMP routes.
maximum load-balancing maximum
Optional.
By default, the maximum
number of ECMP routes
depends on the device model,
as shown in the following
table.
All firewalls support the maximum load-balancing maximum command, and the maximum argument has
different default values: