H3C Technologies H3C SecPath F1000-E - Manual (Page 140)

115
Step Command Remarks
6. Set a password for the local
user.
password { cipher | simple }
password
N/A
7. Configure the service type of
the local user as PPP.
service-type ppp N/A
8. Return to system view. quit N/A
9. Create an ISP domain or enter
an existing ISP domain view. domain isp-name
Optional.
To configure the ppp
authentication-mode command
with an ISP domain specified
which is not the default domain
system, configure this command
before configuring the ppp
authentication-mode command.
10. Configure local authentication
for the PPP users.
authentication ppp local Optional.
NOTE:
For more information about local user configuration and domain configuration, see Access Control
Configuration Guide.
Configuring the authenticatee
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a VT interface and
enter its view.
interface virtual-template number N/A
3. Configure the PAP username
and password sent from the
local device to the peer when
the local device is
authenticated by the peer by
using PAP.
ppp pap local-user username
password { cipher | simple }
password
By default, when being
authenticated by the peer using
PAP, the local device sends null
username and password to the
peer.
Configuring CHAP authentication
According to whether the authenticator is configured with a username or not, the configuration of CHAP
authentication includes the following two types:
Configuring CHAP authentication when the authenticator name
is configured
To configure the authenticator: