H3C Technologies H3C SecPath F1000-E - Manual (Page 470)

445
The page for displaying the BGP peer information appears.
Figure 279 Displaying BGP peer information
Table 69 Field description
Field Description
Peer IP Address IP address of the BGP peer
Peer AS AS number of the BGP peer
Version BGP version
State Current state of the BGP peer
BGP configuration example in the web interface
Network requirements
In the following figure are all BGP devices. Between Device A and SecPath is an EBGP connection. IBGP
speakers SecPath, Device B, and Device C are fully meshed.
Figure 280 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces and configure security zones. (Details not shown)
2. Configure IBGP connections:
# Configure SecPath.
a. Select Network > Routing Management > BGP from the navigation tree.
The BGP configuration page appears.