H3C Technologies H3C SecPath F1000-E - Manual (Page 437)

412
Step Command Remarks
3. Enable OSPF trap generation.
snmp-agent trap enable ospf
[ process-id ] [ ifauthfail | ifcfgerror |
ifrxbadpkt | ifstatechange |
iftxretransmit |
lsdbapproachoverflow |
lsdboverflow | maxagelsa |
nbrstatechange | originatelsa |
vifcfgerror | virifauthfail |
virifrxbadpkt | virifstatechange |
viriftxretransmit |
virnbrstatechange ] *
Optional.
Enabled by default.
Enabling message logging
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] * N/A
3. Enable message logging. enable log [ config | error | state ] Not enabled by default.
Enabling the advertisement and reception of opaque LSAs
With this feature enabled, OSPF can receive and advertise Type 9, Type 10, and Type 11 opaque LSAs.
To enable the advertisement and reception of opaque LSAs:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] * N/A
3. Enable the advertisement and
reception of opaque LSAs.
opaque-capability enable
Optional.
Disabled by default.
Configuring OSPF to give priority to receiving and processing hello packets
To ensure OSPF runs properly, a router receives and processes Hello packets and other protocol packets
at the same time. When the router has established neighbor relationships with multiple routers and the
routing table size is big, the router needs to receive and process large numbers of packets. In this case,
you can configure OSPF to give priority to receiving and processing Hello packets to ensure stable
neighbor relationships.
To configure OSPF to give priority to receiving and processing Hello packets:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure OSPF to give priority
to receiving and processing
Hello packets.
ospf packet-process
prioritized-treatment
Not configured by default.