H3C Technologies H3C SecPath F1000-E - Manual (Page 726)

701
Network requirements
As shown in Figure 360 , a host, Router A and Router B are connected through Ethernet interfaces.
Configure IPv6 addresses for the interfaces and verify that they are connected.
• The global unicast address of GigabitEthernet 0/1 and GigabitEthernet 0/2 on Router A are
3001::1/64 and 2001::1/64 respectively.
• The global unicast address of GigabitEthernet 0/1 on Router B is 3001::2/64, and a route to Host
is available.
• Host is enabled with IPv6 to automatically obtain an IPv6 address through IPv6 ND, and has a
route to Router B.
Figure 360 Network diagram
Configuration procedure
1. Configure Router A:
# Enable IPv6.
system-view
[RouterA] ipv6
# Assign a global unicast address for interface GigabitEthernet 0/1.
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] ipv6 address 3001::1/64
[RouterA-GigabitEthernet0/1] quit
# Assign a global unicast addresses for interface GigabitEthernet 0/2 and allow it to advertise RA
messages (no interface advertises RA messages by default).
[RouterA] interface GigabitEthernet 0/2
[RouterA-GigabitEthernet0/2] ipv6 address 2001::1/64
[RouterA-GigabitEthernet0/2] undo ipv6 nd ra halt
[RouterA-GigabitEthernet0/2] quit
2. Configure Router B:
# Enable IPv6.
system-view
[RouterB] ipv6
# Assign a global unicast address for interface GigabitEthernet 0/1.
[RouterB] interface GigabitEthernet 0/1
[RouterB-GigabitEthernet0/1] ipv6 address 3001::2/64
[RouterB-GigabitEthernet0/1] quit
# Configure an IPv6 static route with destination IP address 2001::/64 and next hop address
3001::1.
[RouterB] ipv6 route-static 2001:: 64 3001::1
3. Configure Host: