H3C Technologies H3C SecPath F1000-E - Manual (Page 268)

243
1. Host A looks through its ARP table for an ARP entry for Host B. If one entry is found, Host A uses
the MAC address in the entry to encapsulate the IP packet into a data link layer frame and sends
the frame to Host B.
2. If Host A finds no entry for Host B, Host A buffers the packet and broadcasts an ARP request using
the following information:
{
Sender IP address and sender MAC address—Host A's IP address and MAC address
{
Target IP address—Host B's IP address
{
Target MAC address—An all-zero MAC address
Because the ARP request is a broadcast, all hosts on this subnet can receive the request, but only
the requested host (Host B) will process the request.
3. Host B compares its own IP address with the target IP address in the ARP request. If they are the
same, Host B:
a. Adds the sender IP address and sender MAC address to its ARP table.
b. Encapsulates its MAC address into an ARP reply.
c. Unicasts the ARP reply to Host A.
4. After receiving the ARP reply, Host A:
a. Adds the MAC address of Host B to its ARP table.
b. Encapsulates the MAC address in the IP packet and sends it to Host B.
Figure 151 ARP address resolution process
If Host A and Host B are on different subnets, Host A sends a packet to Host B as follows:
1. Host A sends an ARP request to the gateway. The target IP address in the ARP request is the IP
address of the gateway.
2. After obtaining the MAC address of the gateway from an ARP reply, Host A sends the packet to the
gateway.
3. If the gateway maintains the ARP entry of Host B, it forwards the packet to Host B directly. If not,
it broadcasts an ARP request, in which the target IP address is the IP address of Host B.
4. After obtaining the MAC address of Host B, the gateway sends the packet to Host B.
ARP table
An ARP table stores dynamic and static ARP entries.