H3C Technologies H3C SecPath F1000-E - Manual (Page 747)

722
# Configure the IPv6 addresses of GigabitEthernet 0/1 and GigabitEthernet 0/2 respectively.
[SecPath] interface GigabitEthernet 0/2
[SecPath-GigabitEthernet0/2] ipv6 address 2::1 64
[SecPath-GigabitEthernet0/2] quit
[SecPath] interface GigabitEthernet 0/1
[SecPath-GigabitEthernet0/1] ipv6 address 1::1 64
# Enable DHCPv6 relay agent and specify the DHCPv6 server address on interface GigabitEthernet
0/1.
[SecPath-GigabitEthernet0/1] ipv6 dhcp relay server-address 2::2
Configuring the SecPath as a gateway
# Enable Router A to send RA messages and turn on the M and O flags.
[SecPath-GigabitEthernet0/1] undo ipv6 nd ra halt
[SecPath-GigabitEthernet0/1] ipv6 nd autoconfig managed-address-flag
[SecPath-GigabitEthernet0/1] ipv6 nd autoconfig other-flag
Verifying the configuration
# After completing the configurations, display DHCPv6 server address information on the SecPath.
[SecPath-GigabitEthernet0/1] display ipv6 dhcp relay server-address all
Interface:GE0/1
Server address(es) Output Interface
2::2
# Display packet statistics on the DHCPv6 relay agent.
[SecPath-GigabitEthernet0/1] display ipv6 dhcp relay statistics
Packets dropped : 0
Error : 0
Excess of rate limit : 0
Packets received : 14
SOLICIT : 0
REQUEST : 0
CONFIRM : 0
RENEW : 0
REBIND : 0
RELEASE : 0
DECLINE : 0
INFORMATION-REQUEST : 7
RELAY-FORWARD : 0
RELAY-REPLY : 7
Packets sent : 14
ADVERTISE : 0
RECONFIGURE : 0
REPLY : 7
RELAY-FORWARD : 7
RELAY-REPLY : 0