Symptom 3, Analysis, Solution – H3C Technologies H3C SecPath F1000-E User Manual
Page 151
126
Symptom 3
Configure an IPv6 address on a PPP-encapsulated interface when IPv6 is disabled. The PPP link fails
IPv6CP negotiation and cannot go up. After enabling IPv6, the interface still cannot go up.
Analysis
IPv6CP negotiation cannot succeed when IPv6 is disabled. As IPv6CP does not support re-negotiation,
IPv6CP negotiation cannot succeed even if you enable IPv6 subsequently.
Solution
To resolve the problem, do the following:
•
Enable IPv6 before configuring an IPv6 address on a PPP link.
•
If IPv6CP negotiation fails, re-enable the interface with the shutdown command and the undo
shutdown command to re-enable IPv6CP negotiation.
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer