H3C Technologies H3C SecPath F1000-E - Manual (Page 293)

268
To do… Use the command Remarks
Enter the view of the
ten-GigabitEthernet interface that
connects to the firewall card
interface ten-gigabitethernet
interface-number
Required
Configure the link type of the
interface as trunk
port link-type trunk Required
Assign the trunk port to the two
VLANs port trunk permit vlan { vlan-id-list |
all }
Required
Configure the default VLAN for the
trunk port
port trunk pvid vlan vlan-id
Optional
The default VLAN cannot be one of
the previously configured two
VLANs.
Configure the firewall card
Follow these steps to configure the firewall card:
To do… Use the command… Remarks
Enter system view system-view —
Create two VLANs and enter VLAN
view.
vlan vlan-id Required
Exit to system view quit —
Enter the view of the
ten-GigabitEthernet interface that
connects to the switch
interface ten-gigabitethernet
interface-number
Required
Configure the operating mode of
the interface as Layer 2
port link-mode bridge
Required
The default operating mode is
Layer 3.
Configure the link type of the
ten-GigabitEthernet interface as
trunk
port link-type trunk Required
Assign the trunk port to the
specified VLANs port trunk permit vlan { vlan-id-list
| all }
Required
The VLANs of the firewall card and
the VLANs on the switch must be
included.
Create a VLAN interface and enter
its view interface vlan-interface
vlan-interface-id
Required
The vlan-interface-id must be one of
the VLAN IDs created on the
switch.
Assign an IP address to the VLAN
interface ip address ip-address { mask |
mask-length } [ sub ]
Required
By default, the VLAN interface has
no IP address.