H3C Technologies H3C SecPath F1000-E - Manual (Page 444)

419
Sum-Net 10.5.1.0 10.2.1.1 769 28 80000003 3
Sum-Net 10.3.1.0 10.2.1.1 1069 28 8000000F 2
Sum-Net 10.1.1.0 10.2.1.1 1069 28 8000000F 1
Sum-Asbr 10.3.1.1 10.2.1.1 1069 28 8000000F 1
# Display OSPF routing information on Router D.
[RouterD] display ospf routing
OSPF Process 1 with Router ID 10.5.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
10.2.1.0/24 3 Inter 10.3.1.1 10.3.1.1 0.0.0.2
10.3.1.0/24 1 Transit 10.3.1.2 10.3.1.1 0.0.0.2
10.4.1.0/24 4 Inter 10.3.1.1 10.3.1.1 0.0.0.2
10.5.1.0/24 1 Stub 10.5.1.1 10.5.1.1 0.0.0.2
10.1.1.0/24 2 Inter 10.3.1.1 10.3.1.1 0.0.0.2
Total Nets: 5
Intra Area: 2 Inter Area: 3 ASE: 0 NSSA: 0
# Ping 10.4.1.1 to test connectivity.
[RouterD] ping 10.4.1.1
PING 10.4.1.1: 56 data bytes, press CTRL_C to break
Reply from 10.4.1.1: bytes=56 Sequence=2 ttl=253 time=2 ms
Reply from 10.4.1.1: bytes=56 Sequence=2 ttl=253 time=1 ms
Reply from 10.4.1.1: bytes=56 Sequence=3 ttl=253 time=1 ms
Reply from 10.4.1.1: bytes=56 Sequence=4 ttl=253 time=1 ms
Reply from 10.4.1.1: bytes=56 Sequence=5 ttl=253 time=1 ms
--- 10.4.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/2 ms
Configuring OSPF route redistribution at the CLI
Network requirements
As shown in Figure 268 :
• All the routers run OSPF, and the AS is divided into three areas.
• Router A and Router B act as ABRs to forward routes between areas.
SecPath is configured as an ASBR to redistribute external routes (static routes). Routing information is
propagated properly in the AS.