H3C Technologies H3C SecPath F1000-E - Manual (Page 395)

370
Figure 250 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure OSPF basic functions:
# Configure Router A.
system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 10.5.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] network 10.2.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
# Configure Router B.
system-view
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] network 10.6.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
# Configure SecPath.
system-view
[SecPath] ospf
[SecPath-ospf-1] area 0
[SecPath-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SecPath-ospf-1-area-0.0.0.0] network 10.2.1.0 0.0.0.255
[SecPath-ospf-1-area-0.0.0.0] quit
3. Configure RIP basic functions:
# Configure SecPath.
system-view
[SecPath] rip 1
[SecPath-rip-1] network 11.3.1.0
[SecPath-rip-1] version 2
[SecPath-rip-1] undo summary
# Configure Router C.
system-view