H3C Technologies H3C SecPath F1000-E - Manual (Page 365)

340
Basic static route configuration example at the CLI
Network requirements
The firewalls' interfaces and the hosts' IP addresses and masks are shown in Figure 237 . Static routes are
required for interconnections between any two hosts.
Figure 237 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure static routes:
# Configure a default route on SecPath A.
system-view
[SecPathA] ip route-static 0.0.0.0 0.0.0.0 1.1.4.2
# Configure two static routes on SecPath B.
system-view
[SecPathB] ip route-static 1.1.2.0 255.255.255.0 1.1.4.1
[SecPathB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on SecPath C.
system-view
[SecPathC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
3. Configure the hosts:
The default gateways for Host A, Host B and Host C are 1.1.2.3, 1.1.6.1 and 1.1.3.1,
respectively. (Details not shown)
4. Verify the configuration:
# Display the IP routing table of SecPath A.
[SecPathA] display ip routing-table
Routing Tables: Public
Destinations : 7 Routes : 7
Destination/Mask Proto Pre Cost NextHop Interface
0.0.0.0/0 Static 60 0 1.1.4.2 GE0/2