N in, Figure 154 – H3C Technologies H3C SecPath F1000-E User Manual
Page 271
246
Figure 154 Dynamic entry management page
•
Click Disable all to disable all interfaces in the list from learning dynamic ARP entries.
•
Select the boxes in front of the interfaces and click Disable selected to disable the selected interfaces
from learning dynamic ARP entries.
•
Click Enable all to enable all interfaces in the list to learn dynamic ARP entries.
•
Select the boxes in front of the interfaces and click Enable selected to enable the selected interfaces
to learn dynamic ARP entries.
•
Click
of an interface to enter the configuration page as shown in
. You can modify
the maximum number of dynamic ARP entries the interface can learn. If it is set to 0, the interface
is not allowed to learn dynamic ARP entries.
Figure 155 Modifying interface configuration
NOTE:
After you enable dynamic ARP learning on an interface as shown in
ARP entries that the interface can learn is restored to the default. By default, an interface can learn up to
4096 dynamic ARP entries.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer