H3C Technologies H3C SecPath F1000-E - Manual (Page 419)

394
Task Remarks
Configuring the maximum number of OSPF
routes
Optional
Configuring the maximum number of ECMP
routes
Optional
Configuring OSPF preference Optional
Configuring OSPF route redistribution Optional
Tuning and optimizing OSPF networks
Configuring OSPF packet timers Optional
Specifying LSA transmission delay Optional
Specifying SPF calculation interval Optional
Specifying the LSA arrival interval Optional
Specifying the LSA generation interval Optional
Disabling interfaces from receiving and
sending OSPF packets
Optional
Configuring stub routers Optional
Configuring OSPF authentication Optional
Adding the interface MTU into DD packets Optional
Configuring the maximum number of external
LSAs in LSDB
Optional
Enabling compatibility with RFC 1583 Optional
Logging neighbor state changes Optional
Configuring OSPF network management Optional
Enabling message logging Optional
Enabling the advertisement and reception of
opaque LSAs
Optional
Configuring OSPF to give priority to receiving
and processing hello packets
Optional
Configuring the LSU transmit rate Optional
Enabling OSPF ISPF Optional
Configuring BFD for OSPF Optional
Enabling OSPF
You must enable OSPF before performing other OSPF configuration tasks.
Configuration prerequisites
Configure the link layer protocol, and IP addresses for interfaces so that neighboring nodes can reach
each other.