H3C Technologies H3C SecPath F1000-E - Manual (Page 711)

686
IPv6 basics configuration task list
Task Remarks
Configuring basic IPv6 functions
Enabling IPv6 Required
Configuring an IPv6 global unicast address Required
to
configure
one
Configuring an IPv6 link-local address
Configure an IPv6 anycast address
Configuring IPv6 ND
Configuring a static neighbor entry Optional
Configuring the maximum number of neighbors dynamically
learned
Optional
Setting the aging timer for ND entries in stale state Optional
Configuring parameters related to RA messages Optional
Configuring the maximum number of attempts to send an NS
message for DAD
Optional
Enabling ND proxy Optional
Configuring path MTU
discovery
Configuring the interface MTU Optional
Configuring a static path MTU for a specific IPv6 address Optional
Configuring the aging time for dynamic path MTUs Optional
Configuring IPv6 TCP properties Optional
Configuring IPv6 FIB load sharing Optional
Configuring ICMPv6 packet
sending
Configuring the maximum ICMPv6 error packets sent in an
interval
Optional
Enabling replying to multicast echo requests Optional
Enabling sending of ICMPv6 time exceeded messages Optional
Enabling sending of ICMPv6 destination unreachable
messages
Optional
Configuring basic IPv6 functions
Enabling IPv6
Enable IPv6 before you perform any IPv6-related configuration. Without IPv6 enabled, an interface
cannot forward IPv6 packets even if it has an IPv6 address configured.
To enable IPv6:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable IPv6. ipv6 Disabled by default.