H3C Technologies H3C SecPath F1000-E - Manual (Page 793)

768
3.3.3.3 1 Full/Backup 00:00:34 GE0/1 0
OSPFv3 Area ID 0.0.0.1 (Process 1)
----------------------------------------------------------------------
Neighbor ID Pri State Dead Time Interface Instance ID
1.1.1.1 1 Full/DR 00:00:35 GE0/2 0
# Display OSPFv3 neighbor information on SecPath C.
[SecPathC] display ospfv3 peer
OSPFv3 Area ID 0.0.0.0 (Process 1)
----------------------------------------------------------------------
Neighbor ID Pri State Dead Time Interface Instance ID
2.2.2.2 1 Full/DR 00:00:35 GE0/1 0
OSPFv3 Area ID 0.0.0.2 (Process 1)
----------------------------------------------------------------------
Neighbor ID Pri State Dead Time Interface Instance ID
4.4.4.4 1 Full/Backup 00:00:36 GE0/2 0
# Display OSPFv3 routing information on SecPath D.
[SecPathD] display ospfv3 routing
E1 - Type 1 external route, IA - Inter area route, I - Intra area route
E2 - Type 2 external route, * - Selected route
OSPFv3 Router with ID (4.4.4.4) (Process 1)
------------------------------------------------------------------------
*Destination: 2001::/64
Type : IA Cost : 2
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
*Destination: 2001:1::/64
Type : IA Cost : 3
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
*Destination: 2001:2::/64
Type : I Cost : 1
NextHop : directly-connected Interface: GE0/2
*Destination: 2001:3::/64
Type : IA Cost : 4
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
3. Configure Area 2 as a stub area:
# Configure SecPath D.
[SecPathD] ospfv3
[SecPathD-ospfv3-1] area 2
[SecPathD-ospfv3-1-area-0.0.0.2] stub