H3C Technologies H3C SecPath F1000-E - Manual (Page 543)

518
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A
3. Specify the authentication
mode and password. isis authentication-mode { md5 | simple }
password [ level-1 | level-2 ] [ ip | osi ] By default, no authentication
is configured.
NOTE:
•
The level-1 and level-2 keywords are configurable on an interface that has IS-IS enabled with the isis
enable command.
• If you configure an authentication mode and a password without specifying a level, the authentication
mode and password apply to both Level-1 and Level-2.
• If neither ip nor osi is specified, the OSI related fields in LSPs are checked.
Configuring area authentication
Area authentication enables a router not to install routing information from untrusted routers into the
Level-1 LSDB. The router encapsulates the authentication password in the specified mode into Level-1
packets (LSP, CSNP, PSNP) and check the password in received Level-1 packets.
Routers in a common area must have the same authentication mode and password.
To configure area authentication:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the area
authentication mode and
password.
area-authentication-mode { md5 |
simple } password [ ip | osi ] By default, no area authentication
is configured.
Configuring routing domain authentication
Routing domain authentication prevents untrusted routing information from entering into a routing
domain. A router with the authentication configured encapsulates the password in the specified mode
into Level-2 packets (LSP, CSNP, PSNP) and check the password in received Level-2 packets.
All the routers in the backbone must have the same authentication mode and password.
To configure routing domain authentication:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A