H3C Technologies H3C SecPath F1000-E - Manual (Page 599)

574
Figure 323 Network diagram
Configuration procedure
1. Configure IP addresses:
Configure the IP address and mask for each interface as per
Figure 323 . (Details not shown.)
2. Configure a GRE tunnel:
# Create Tunnel 0 on SecPath A and configure the IP address and mask for the interface.
system-view
[SecPathA] interface tunnel 0
[SecPathA-Tunnel0] ip address 50.1.1.1 24
# Configure Tunnel 0 to work in the GRE tunnel mode and specify the source and destination
addresses of the interface.
[SecPathA-Tunnel0] tunnel-protocol gre
[SecPathA-Tunnel0] source 20.1.1.1
[SecPathA-Tunnel0] destination 30.1.1.2
[SecPathA-Tunnel0] quit
# Create Tunnel 0 on SecPath C and configure the IP address and mask for the interface.
system-view
[SecPathC] interface tunnel 0
[SecPathC-Tunnel0] ip address 50.1.1.2 24
# Configure Tunnel to operate in the GRE tunnel mode and configure the source and destination
addresses of the interface.
[SecPathC-Tunnel0] tunnel-protocol gre
[SecPathC-Tunnel0] source 30.1.1.2
[SecPathC-Tunnel0] destination 20.1.1.1
[SecPathC-Tunnel0] quit
3. Configure OSPF:
# Configure OSPF on SecPath A.
[SecPathA] ospf 1
[SecPathA-ospf-1] area 0
[SecPathA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] network 50.1.1.0 0.0.0.255
[SecPathA-ospf-1-area-0.0.0.0] quit
[SecPathA-ospf-1] quit