H3C Technologies H3C SecPath F1000-E - Manual (Page 320)

295
Item Description
Policy Name Select the QoS policy to be applied.
Direction
Specify the direction in which the policy is to be applied.
• Inbound—Applies the policy to the incoming packets on the specified interface.
• Outbound—Applies the policy to the outgoing packets on the specified interface.
Configuring port bandwidth limit
Configuring port bandwidth limit is to set the maximum available bandwidth on a port. This setting is
used in place of actual physical port bandwidth for bandwidth check when CBQ enqueues packets.
If no maximum available bandwidth is configured for an interface, the bandwidth used for CBQ
calculation varies by the interface type following these rules:
• If the interface is a physical one, the actual baud rate or rate applies.
• If the interface is a template interface, a virtual template (VT) interface for example, 1000000 kbps
applies.
• If the interface is a virtual interface, a tunnel interface for example, 0 kbps applies.
Select Firewall > QoS > PortBandwidth from the navigation tree, and click Setup to enter the page for
configuring port bandwidth limit, as shown in Figure 189 .
Figure 189 Port bandwidth
Table 53 Configuration items
Item Description
Bandwidth Limit Enable or disable port bandwidth limit for selected ports.
Max Bandwidth
Set the maximum available port bandwidth.
H3C recommends that you set the maximum available port bandwidth to be smaller
than the actual available bandwidth of the physical interface or logical link.
Interface Select the port or ports to be configured with port bandwidth limit from the port list.