H3C Technologies H3C SecPath F1000-E - Manual (Page 661)

636
[SecPathA] interface GigabitEthernet 0/2
[SecPathA-GigabitEthernet0/2] pim sm
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] interface GigabitEthernet 0/3
[SecPathA-GigabitEthernet0/3] pim sm
[SecPathA-GigabitEthernet0/3] quit
The configuration on Router A and Router B is similar to that on SecPath A. The configuration on
SecPath B and SecPath C is also similar to that on SecPath A except that it is not necessary to
enable IGMP on the corresponding interfaces on these two routers.
3. Configure a C-BSR and a C-RP:
# On SecPath B, configure the service scope of RP advertisements, specify a C-BSR and a C-RP,
and set the hash mask length to 32 and the priority of the C-BSR to 10.
system-view
[SecPathB] acl number 2005
[SecPathB-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SecPathB-acl-basic-2005] quit
[SecPathB] pim
[SecPathB-pim] c-bsr GigabitEthernet 0/3 32 10
[SecPathB-pim] c-rp GigabitEthernet 0/3 group-policy 2005
[SecPathB-pim] quit
# On SecPath C, configure the service scope of RP advertisements, specify a C-BSR and a C-RP,
and set the hash mask length to 32 and the priority of the C-BSR to 20.
system-view
[SecPathC] acl number 2005
[SecPathC-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SecPathC-acl-basic-2005] quit
[SecPathC] pim
[SecPathC-pim] c-bsr GigabitEthernet 0/3 32 20
[SecPathC-pim] c-rp GigabitEthernet 0/3 group-policy 2005
[SecPathC-pim] quit
4. Verify the configuration:
Use the display pim interface command to display PIM information on each interface of firewalls.
For example:
# Display PIM configuration information on SecPath A.
[SecPathA] display pim interface
Interface NbrCnt HelloInt DR-Pri DR-Address
GE0/1 0 30 1 10.110.1.1 (local)
GE0/2 1 30 1 192.168.9.2
GE0/3 1 30 1 192.168.1.2
To display BSR election information and the locally configured C-RP information in effect on a
firewall, use the display pim bsr-info command. For example:
# Display BSR information and the locally configured C-RP information in effect on SecPath A.
[SecPathA] display pim bsr-info
Elected BSR Address: 192.168.9.2
Priority: 20
Hash mask length: 32
State: Accept Preferred