H3C Technologies H3C SecPath F1000-E - Manual (Page 784)

759
Step Command Remarks
3. Configure an OSPFv3
cost for the interface. ospfv3 cost value [ instance
instance-id ]
Optional.
The default cost depends on the interface type:
1 for a VLAN interface; 0 for a loopback
interface; computed according to the
bandwidth for other interfaces.
To configure a bandwidth reference value:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
Optional.
100 Mbps by default.
Configuring the maximum number of ECMP routes
Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of load-balanced routes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A
3. Specify the maximum number
of ECMP routes. maximum load-balancing
maximum
Optional.
8 by default.
Configuring a priority for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is selected.
To configure a priority for OSPFv3:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A
3. Configure a priority for
OSPFv3. preference [ ase ] [ route-policy
route-policy-name ] preference
Optional.
By default, the priority of OSPFv3 internal
routes is 10, and priority of OSPFv3
external routes is 150.