H3C Technologies H3C SecPath F1000-E - Manual (Page 811)

786
Configuring IPv6 BGP basic functions
Configuration prerequisites
Before you configure IPv6 BGP basic functions, complete the following tasks:
• Specify IP addresses for interfaces.
• Enable IPv6.
NOTE:
You need create a peer group before configuring basic functions for it. For related information, see
"
Configuring IPv6 BGP peer group ."
Specifying an IPv6 BGP peer
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Specify a router ID. router-id router-id
Optional.
Required if no IP addresses are
configured for any interfaces.
4. Enter IPv6 address family view
or IPv6 BGP-VPN instance
view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
5. Specify an IPv6 peer.
peer ipv6-address as-number
as-number
N/A
Injecting a local IPv6 route
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view
or IPv6 BGP-VPN instance
view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
4. Inject a local route into the
IPv6 BGP routing table.
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
Not added by default