H3C Technologies H3C SecPath F1000-E - Manual (Page 579)

554
[SecPath] ip local policy-based-route aaa
# Configure the IP addresses of the GigabitEthernet ports.
[SecPath] interface GigabitEthernet 0/1
[SecPath-GigabitEthernet 0/1] ip address 1.1.2.1 255.255.255.0
[SecPath-GigabitEthernet 0/1] quit
[SecPath] interface GigabitEthernet 0/2
[SecPath-GigabitEthernet 0/2] ip address 1.1.3.1 255.255.255.0
2. Configure Router A:
# Configure the IP address of GigabitEthernet 0/1.
system-view
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] ip address 1.1.2.2 255.255.255.0
[RouterA-GigabitEthernet0/1] quit
3. Configure Router B:
# Configure the IP address of GigabitEthernet 0/1.
system-view
[RouterB] interface GigabitEthernet 0/1
[RouterB-GigabitEthernet0/1] ip address 1.1.3.2 255.255.255.0
[RouterB-GigabitEthernet0/1] quit
4. Verify the configuration:
# Telnet to Router A (1.1.2.2/24) from SecPath. The operation succeeds.
telnet 1.1.2.2
Trying 1.1.2.2 ...
Press CTRL+K to abort
Connected to 1.1.2.2 ...
******************************************************************************
* Copyright (c) 2004-2011 Hangzhou H3C Tech. Co., Ltd. All rights reserved. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
# Telnet to Router B (1.1.3.2/24) from SecPath. The operation fails.
telnet 1.1.3.2
Trying 1.1.3.2 ...
Press CTRL+K to abort
Can't connect to the remote host!
# Ping Router B (1.1.3.2/24) from SecPath. The operation succeeds.
ping 1.1.3.2
PING 1.1.3.2: 56 data bytes, press CTRL_C to break
Reply from 1.1.3.2: bytes=56 Sequence=1 ttl=255 time=2 ms
Reply from 1.1.3.2: bytes=56 Sequence=2 ttl=255 time=1 ms
Reply from 1.1.3.2: bytes=56 Sequence=3 ttl=255 time=1 ms
Reply from 1.1.3.2: bytes=56 Sequence=4 ttl=255 time=1 ms
Reply from 1.1.3.2: bytes=56 Sequence=5 ttl=255 time=1 ms
--- 1.1.3.2 ping statistics ---
5 packet(s) transmitted