H3C Technologies H3C SecPath F1000-E - Manual (Page 359)

334
Figure 234 Creating a static route
3. Create a static route as described in Table 58 .
Table 58 Configuration items
Item Description
Destination Enter the destination IP address in dotted decimal notation.
Mask Specify the destination IP address mask.
Next Hop Enter the next hop IP address in dotted decimal notation.
Outbound Interface Specify the outgoing interface.
Priority
Enter the static route priority.
The static route priority defaults to 60.
Static route configuration example in the web
interface
Network requirements
Configure IP addresses and masks for the interfaces and hosts as shown in Figure 235 . Configure static
routes between the hosts so that any two hosts can communicate with each other.