H3C Technologies H3C SecPath F1000-E - Manual (Page 539)

514
Figure 296 Network diagram of a fully meshed network
To avoid this, configure some interfaces as a mesh group, configure the blocked interfaces, or both.
• After receiving an LSP, a member interface in a mesh group floods it out the interfaces that does not
belong to the mesh group.
• If an interface is blocked, it does not send LSPs unless the neighbor sends LSP requests to it.
Before configuring this task, you need to consider redundancy for interfaces in case that LSP packets
cannot be flooded due to link failures.
To add an interface into a mesh group and block an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Add the interface to a mesh
group or block the interface.
• Add the interface to a mesh
group:
isis mesh-group
mesh-group-number
• Block the interface:
isis mesh-group mesh-blocked
Use either approach.
By default, the interface neither
belongs to any mesh group nor is
blocked.
NOTE:
The mesh group feature takes effect only on P2P interfaces.
Configuring SPF parameters
When the LSDB changes on a router, a route calculation starts. Frequent route calculations consume a lot
of system resources. You can set an appropriate interval for SPF calculations to improve efficiency.
To configure the SPF parameters:
Step Command Remarks
1. Enter system view. system-view N/A
Eth1/1
Eth1/2
Eth1/3
Eth1/1
Eth1/1
Eth1/2
Eth1/3
Eth1/1
Eth1/2
Eth1/3
Eth1/2
Eth1/3
Router A
Router B Router C
Router D