H3C Technologies H3C SecPath F1000-E - Manual (Page 845)

820
• Configure IP addresses for interfaces, and make sure all neighboring nodes are reachable.
• Enable IS-IS.
Configuration procedure
To configure the basic functions of IPv6 IS-IS:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable an IS-IS process and
enter IS-IS view.
isis [ process-id ] Not enabled by default.
3. Configure the network entity
title for the IS-IS process.
network-entity net Not configured by default.
4. Enable IPv6 for the IS-IS
process.
ipv6 enable Disabled by default.
5. Return to system view. quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable IPv6 for an IS-IS
process on the interface.
isis ipv6 enable [ process-id ] Disabled by default.
Configuring IPv6 IS-IS routing information control
Configuration prerequisites
You need to complete the IPv6 IS-IS basic function configuration before configuring this task.
Configuration procedure
To configure IPv6 IS-IS routing information control:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter IS-IS view. isis [ process-id ] N/A
3. Define the priority for IPv6
IS-IS routes.
ipv6 preference { route-policy
route-policy-name | preference } * Optional.
15 by default.
4. Configure an IPv6 IS-IS
summary route.
ipv6 summary ipv6-prefix prefix-length
[ avoid-feedback | generate_null0_route |
[ level-1 | level-1-2 | level-2 ] | tag tag ] *
Optional
Not configured by default
5. Generate an IPv6 IS-IS
default route.
ipv6 default-route-advertise [ [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name ] *
Optional.
No IPv6 default route is
defined by default.